Labels

Books (20) CCDA (2) CCDP (1) CCNA DC (2) CCNA RS (7) CCNA Security (4) CCNA Voice (3) CCNA Wireless (3) CCNP RS (4) CCNP Security (1) CCNP SP (2) CCNP Voice (3) certifications (20) Cisco (18) Cisco Nexus (3) General (4) Hardware (1) JNCIA (6) JNCIE (2) JNCIP (2) JNCIS (2) Juniper (6) SDN (6) SP (3)

Translate

CCNA IP Addressing/VLSM





title

CCNA IP Addressing/VLSM --- 19 Questions

Question 1 Refer to the exhibit ?

Host A pings S0/0 on router 3. What is the TTL value for that ping ?

Question 2 Which command can be used from a PC to verify the connectivity between hosts that connect through a switch in the same LAN?

Question 3 An administrator must assign static IP addresses to the server in a network.

For network 192.168.20.24/29, the router is assigned the first usable address while the sales server is given the last usable host address

Which of the following should be entered into IP properties box for the sales server?

Question 4 Which subnet mask would be appropriate for a network address range to be submitted for upto eight LAN's, with each LAN containing 5 to 26 hosts?

Question 5 A national retail chain need to design an IP addressing scheme to support a nationwide network

The company needs a minimum of 300 sub-networks and a maximum of 50 host addresses per subnet.

Working with only one Class B address, which of the following subnet masks will support an appropriate addressing scheme? (Choose two)

Question 6 When a DHCP server is configured, which two IP addresses should never be assignable to hosts? (Choose two)

Question 7 What will happen if a private IP address is assigned to a public interface connected to an ISP?

Question 8 Refer to the exhibit.
An administrator pings the default gateway at 10.10.10.1 and sees the output as shown. At which OSI layer is the problem?

Question 9 Refer to the exhibit.A new subnet with 60 hosts has been added to the network.
Which subnet address should this network use to provide enough usable addresses while wasting the fewes addresses?

Question 10 Refer to the exhibit.
All of the routers in the network are configured with the ip bunet-zero command.
Which network addresses should be used for Link A and Network A? (Choose two)

Question 11 Refer to the exhibit.Which subnet mask will place all hosts on Network B in the same subnet with the least amount of wasted addresses?

Question 12 Refer to the exhibit.What is the most appropriate summarization for these routes?

Question 13 Given an IP address 172.16.28.252 with a subnet mask of 255.255.240.0, what is the correct network address?

Question 14 You are working in a data center environment and are assigned the address range 10.188.31.0/23.
You are asked to develop an IP addressing plan to allow the maximum number of subnets with as many as 30 hosts each.
Which IP address range meets these requirements?

Question 15 The network administrator needs to address seven LAN's. RIP version 1 is the only routing protocol in use on the network and subnet 0 is not being used.
What is the maximum number of usable IP addresses that can be supported on each LAN if the organization is uring on class C address block?

Question 16 Refer to the exhibit. The networks connected to router R2 have been summarized as a 192.168.176.0/21 route and sent to R1. Which two packet destination addresses will R1 forward to R2? (Choose two)

Question 17 Which ip address would a network technician ping on the local host, to test the ip stack?

Question 18 How many subnets can be gained by subnetting 172.17.32.0/23 into a /27 mask, and how many usable host addresses will there be per subnet?

Question 19 The network administrator has asked you to check the status of the workstation's IP stack by pinging the loopback address. Which address would you ping to perform this task?

2 comments:

  1. @Admin,
    Q.6 is correct fro option B.Broadcast address as well.
    Please correct, it shows in red

    ReplyDelete